Prime Power Generators: Genset J110K

Model	J110K
88 KW/110 kVA	80 kW / 100 kVA
Stand-by Power @ 50 Hz	Prime Power @ 50 Hz

Standard Features

Engine (JOHN DEERE , 4045DF120 )
Charge alternator 12 V, Governor: Meca
Alternator (MECC ALTE , LSA442VS45 )
Single bearing alternator IP 23 , insulation class H /H
Radiator 50°C [122°F] °C max. T° air inlet with coolant cap
Skid and vibration isolators
Dry type air filter
Microprocessor control panel
Main line circuit breaker
12 V battery, rack and cable
Industrial silencer (loose)
User manual

Generator Ratings

Voltage	HZ	Phase	PF	Stand By Amps	Stand by power kW/kVA	Prime Power kW/kVA
415/240 MONO V	50 Hz	3	0.8	153	88/110	80/100
400/230 MONO V	50 Hz	3	0.8	159	88/110	80/100
380/220 MONO V	50 Hz	3	0.8	167	88/110	80/100
240/120 MONO V	50 Hz	3	0.8	265	88/110	80/100
230/115 MONO V	50 Hz	3	0.8	276	88/110	80/100
220/110 MONO V	50 Hz	3	0.8	289	88/110	80/100
220/127 MONO V	50 Hz	3	0.8	289	88/110	80/100
200/115 MONO V	50 Hz	3	0.8	318	88/110	80/100

PRP: Prime Power is available for an unlimited number of annual operating hours in variable load applications, in accordance with ISO 8528-1. A 10% overload capability is available for a period of 1 hour within 12-hour period of operation, in accordance with ISO 3046-1

ESP:The standby power rating is applicable for supplying emergency power in variable load applications in accordance with ISO8528-1. Overload is not allowed.

Conditions of sales

SDMO provides a full line of products with high quality recognized engines and alternators.
Service and parts are available from SDMO distributors as a single source of responsibility.

Each and every units is factory tested. All generator sets are also prototype tested.
Warranty according to our standard conditions. Five years extended also available.

Call Us on 01794 521355

J110K specifications and design liable to modifications without prior notice

Engine Specifications

Engine Data

Manufacturer / Model :

4045HF120 , 4-cycle, Turbo , Air/Air DC

Cylinder Arrangement :

4 X L

Displacement :

4.48L [273.4C.I.]

Bore and Stroke :

106mm [4.2in.] X 127mm [5.0in.]

Compression ratio :

17 : 1

Rated RPM :

1500 Rpm

Piston Speed :

6.35m/s [20.8ft./s]

Max. stand by Power at rated RPM :

97kW [130BHP]

Frequency reg, steady state :

+/-2, 5%

BMEP :

16.2bar [235psi]

Governor type:

Meca

Exhaust System

Exhaust gas flow :

283L/s [600cfm]

Exhaust temperature :

545°C [1031°F]

Max back pressure :

750mm CE [30in. WG]

Feul System

110% (Stand By power ) :

25.5L/h [6.7gal/hr]

100% (of the Prime Power) :

23.5L/h [6.2gal/hr]

75% (of the Prime Power) :

16.5L/h [4.4gal/hr]

50% (of the Prime Power) :

11.5L/h [3.0gal/hr]

Total fuel flow :

108L/h [28.5gal/hr]

Oil System

Total oil capacity w/filters :

13.5L [3.6gal]

Oil Pressure low idle :

1bar [14.5psi]

Oil Pressure rated RPM :

5bar [72.5psi]

Oil consumption 100% load :

0.024L/h [0.0gal/hr]

Oil capacity carter :

12.5L [3.3gal]

Thermal balance 100% load

Heat rejection to exhaust :

64kW [3639Btu/mn]

Radiated heat to ambiant :

10.5kW [597Btu/mn]

Heat rejection to coolant :

36kW [2047Btu/mn]

Air intake

Max. intake restriction :

624mm CE [25in. WG]

Engine air flow :

106L/s [225cfm]

Coolant System

Radiator & engine capacity :

20.2L [5.3gal]

Max water temperature :

105°C [221°F]

Outlet water temperature :

93°C [199°F]

Fan power :

2.5 kW

Fan air flow(m³/s) :

3.7m³/s [3687cfm]

Available restriction on air flow :

20mm CE [0.8in. WG]

Type of coolant :

Gencool

Thermostat :

82-94 °C(179-201.2°F)

Emissions

HC(mg/Nm³) :

26 mg/Nm³

CO(mg/Nm³) :

310 mg/Nm³

Nox(mg/Nm³) :

2900 mg/Nm³

PM mg/Nm³:

100 mg/Nm³

Call Us on 01794 521355

J110K specifications and design liable to modifications without prior notice

Alternator Specifications

General Data

Compliance with NEMA MG21, UTE NF C51.111, VDE 0530, BS 4999, CSA standards.

Vacuum-impregnated windings with epoxy varnish.
IP21 drip proof.

Alternator

Manufacturer / Type :

LEYROY SOMER LSA442VS45

Number of phase :

Power factor (Cos Phi) :

0.8

Altitude :

<1000m

Overspeed :

2250rpm

Pole Number :

Exciter type :

Shunt

Insulation class, temperature rise :

H/H

Voltage regulator :

R230

Sustained short circuit current:

–

Total harmonics (TGH/THC)

<4%

Wave form : NEMA = TIF – TGH/THC

<50

Wave form : CEI = FHT – TGH/THC :

<2%

Bearing – number :

Coupling :

Direct

Voltage regulation 0 to 100% load :

+/- 1%

Recovery time (20% Volt dip) ms

500ms

SkVA with 90 % of nominal sustained voltage (at 0.4 PF) :

N/A

Other Alternator Data

Continuous nominal rating @ 40°C :

105 kVA

Standby rating @ 27°C :

116 kVA

Efficiencies @ 4/4 load :

90.7 %

Air flow(m³/s) :

0.37m³/s [783.98cfm]

Short circuit ratio (Kcc) :

0.35

Direct axis synchro reactance unsaturated (Xd) :

362 %

Quadra axis synchro reactance unsaturated (Xq) :

217 %

Open circuit time constant (T'do) :

2555 ms

Direct axis transient reactance saturated (X'd) :

14.1 %

Short circuit transient time constant (T'd) :

100 ms

Direct axis subtransient reactance saturated (X''d) :

8.5 %

Subtransient time constant (T''d)

10 ms

Quadra axis subtransient reactance saturated (X''q)

10.4%

Zero sequence reactance unsaturated (Xo) :

0.4 %

Negative sequence reactance saturated (X2) :

9.5 %

Armature time constant (Ta) :

15 ms

No load excitation current (io) :

0.5 A

Full load excitation current (ic) :

2.1 A

Full load excitation voltage (uc) :

38V

Recovery time (Delta U = 20% transitoire) :

500ms

Motor start (Delta = 20% perm. Or 50% trans.):

260kVA

Transient dip (4/4 charge) – PF : 1.8 AR :

17.3%

No load losses :

1.81kW[1.81Kw]

Heat rejection :

8.57 kW

Call Us on 01794 521355

J110K specifications and design liable to modifications without prior notice

Optional Conrol Panels

Standard panel : NEXYS

Specifications :
Frequency meter, Ammeter, Voltmeter
Alarms and faults :
Oil pressure, water temperature, Overcrank, Overspeed ( >60 kVA), Min/max, alternator, Low fuel level, Emergency stop
Engine parameters :
Hours counter, Engine speed, Battery voltage, Fuel level, AIr preheating

Standard panel : TELYS

Specifications :
Frequency meter, Ammeter, Voltmeter
Alarms and faults :
Oil pressure, water temperature, No start-up, Overspeed, Min/max alternator, Min/max battery voltage, Low fuel level, Emergency stop
Engine parameters :
Hours counter, Oil pressure, Water temperature, Engine speed, Battery voltage, Fuel level